Melde's Experiment
Aim. To determine the frequency of a vibrating tuning fork using Melde's arrangement.
Apparatus.
- Electrically maintained tuning fork
- Storage cell eliminator, plug key and connecting wires
- Thread, light card-board pan and a friction-free pulley
- Weights and a metre scale
Principle
When one end of a stretched thread is driven by a vibrating tuning fork, waves travel along the thread, reflect at the pulley and interfere with the incoming waves. At the right tension a stationary wave forms, with a whole number of well-defined loops.
Theory
The speed of a transverse wave on a thread with tension and mass per unit length is
If is the length of one loop, the wavelength is . Two arrangements are used:
Transverse mode (prong vibrates perpendicular to the thread). The thread vibrates at the frequency of the fork:
Longitudinal mode (prong vibrates along the thread). The thread vibrates at half the fork frequency:
The tension is , where is the added load and the mass of the pan. The loop length is for loops over a measured length . Squaring the transverse formula gives , so a graph of against is a straight line.
Procedure checklist
- Connect the fork to the cell eliminator through the plug key, with the electromagnet between the prongs.
- Insert the key and adjust the contact screw until the fork vibrates steadily.
- Tie one end of the thread to the prong screw and pass the other over the pulley (3 to 4 m away) to the pan.
- Add weights gradually until the thread shows sharp, steady loops.
- Measure the length of a convenient number of loops and note the load.
- Repeat for several loads, then weigh a known length of thread to get .
- Calculate for each reading and take the mean.
Precautions
- The pulley must be friction-free and the thread light, uniform and inextensible.
- Measure the loop length from node to node, over as many loops as you can count clearly.
- Keep the pan steady while you note the weights.
Result
The frequency of the tuning fork is Hz.